Hmm detta var ju intressant
CONCLUSION:
1. Nexus 7 OEM charger is nothing special, just the data pins are shorted.
2. Nexus 7 OEM MicroUSB cable is nothing special. It is a standard MicroUSB cable.
3. Any USB car/wall charger should charge the Nexus 7.
4. Nexus 7 will charge regardless of whether it displays "AC Charging" or not.
5. The charging rate is dependent on the capacity of the charger and the total charging circuit impedance (lower the impedance the better).
6. Increasing the length of the cable increases the charging circuit impedance and decreases the charging rate.
SOLUTION:
1. Use a high quality, high amperage USB charger.
2. Use a cable with an AWG of (28/24) or lower.
3. Cables longer than 6 feet is not suggested regardless of lower AWG as the connectors itself (especially at the MicroUSB end) will be the bulk of the impedance for that cable.
4. If you desire to have "AC Charging" be displayed on your Nexus 7, short the data wires/pins. Remember, this has no effect on the charging rate.
5. If you plan to modify the charger, take a resistance measurement of the data pins first (unplugged), any readings other than 0 ohms or infinity (open or not connected), you will need to isolate the data pins from the charging circuit prior to shorting. If you do not, you risk damaging the charger and/or your precious Nexus 7.
6. If you plan to modify the cable, short the data wires at the MicroUSB end and leave the data wires open or not connected at the charger end. Use heat shrink to insulate the exposed conductor of the data wires.
7. Make sure the MicroUSB connector end is about 6.0 mm in length.
Enligt det så bör ju vilken laddare som helst faktiskt fungera? Bara den ger ut rätt mängd ström och kabeln är tillräckligt grov och kort. Finns det någon app som man kan kolla hur hög ström/spänning som plattan laddas med?
Click to expand...