följ denna guide:
Flashing stock firmware
Make sure you don´t have Kies running, and your phone is off, do not connect it now.
1.Start Odin
2.In PIT, load the 512.PIT file.
3.For PDA, select the CODE file.
4.For PHONE, select the MODEM file.
5.For CSC select the CSC file.
6.Make sure that the Re-partition box is checked.
7.Put your phone in download mode. (Volume down + power button + home button )
8.Connect your phone to your PC via the USB cable. It will install the drivers, or if they are already installed, you will see ‘Added’ in Odin’s message box . A COM port will also become visible.
9.Again make sure that all the selections in Odin’s interface are correct. Press the Start button when verified.
The flashing sequence will begin, and you will see several messages in Odin. Make sure that the phone does not disconnect during this time, as it may brick your device permanently. Once the flashing sequence has completed, Odin will give a ‘Completed’ message in the Message box, and a green PASS will appear on top.
Your device will automatically reboot at this point.
Congratulations! You have successfully completed stage one of the process, and now you’re running the XWJM8 or JM9 2.1 Éclair firmware.
Section A is useful if you just want to revert back to factory stock 2.1 (warranty, repairs, etc.)
men använd dessa filer:
http://www19.zippyshare.com/v/93423242/file.html
länk till Odin om du inte har det:
http://www38.zippyshare.com/v/19205818/file.html
EDIT: tack perka & flip360 för guiden
Click to expand...